Jiangsu Tianqi Star robot introduction: How to wire injection molding machine manipulator?

The wiring method of the injection molding machine robot will vary according to the specific robot brand and model. In general, wiring operations include the following steps:

1. First of all, ensure that the power supply of the manipulator and the injection molding machine is turned off to ensure work safety.

2. Find the connection interface between the manipulator and the injection molding machine, usually on the back or side of the manipulator controller, and in the injection molding machine electrical control cabinet.

3. Insert the corresponding cable plug into the correct interface according to the labels of the wiring interface of the manipulator and the injection molding machine. There are usually separate power, signal and communication interfaces.

4. During the wiring process, ensure that the connector corresponds to the slot of the interface and is firmly connected to avoid adverse consequences caused by loose wiring.

5. Check whether cables are correctly and securely connected. Pay special attention to whether the power cable is properly grounded to ensure electrical safety.

Before wiring the manipulator, read the wiring instructions of the manipulator carefully and follow the relevant safety procedures.

Jiangsu Tianqixing Robot Co., Ltd. is an intelligent technology enterprise integrating R&D, production and sales of injection molding automatic servo robots, injection molding robot arms and multi-axis robots. Professional to provide customers with injection molding industry overall automation solutions.