What are the parts of the injection molding machine manipulator?

Focus on R & D, design, production of robots, sales and service in one of the manufacturing enterprises

First, the robot body accessories: according to the tonnage of the injection molding machine, process requirements, etc

1, manipulator control system, common models: single axis, two axes, three axes, five axes, six axes

Note: The controller of the manipulator system should prevent falling and entering oil and water

2, servo drive, commonly used models: 400W, 750W, 1KW, 1.5KW

Note: The servo motor and servo drive must be the same brand and the same series can be used together

3, slide rail slide block, common models: 15-four holes, 20-four holes, 25-four holes

Note: After regular maintenance, clean the dust sludge, inject lubricating oil from the slider nozzle

4, reducer, commonly used models: 400W1:5, 400W1:9, 750W1:5, 750W1:9

Note: The interior is a high-precision planetary gear structure, can not knock knock

5, rack and pinion, commonly used models: helical 1.5 mold, helical 2 mold

Note: After regular maintenance, clean dust and sludge, the tooth surface is evenly coated with lubricating oil

6, synchronous belt, commonly used models: 8M-15, 8M-20, 8M-25, AT10-20, AT10-25, AT10-30

Note: Check regularly for tooth loss, cracks, steel wire exposed phenomenon, abnormal timely replacement

7, cylinder, commonly used models: 20-120, 20-150, 20-200, 25-650, 25-750, 25-850, 32-450, 32-500